### 1. Prepare the Device

Place the **StarLite Mk V** on a **soft, protected surface** to avoid any scratches or damage to the casing.

![I5_1.jpg](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_1.jpg?v=1772459150)

---

### 2. Remove the MicroSD Card Tray

Insert a pin or SIM eject tool into the small hole to release and remove the **MicroSD card tray**.

![image](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_25.jpg?v=1724246055)

---

### 3. Separate the Backplate

Using a **plastic pick**, gently wedge it between the display and the backplate to begin separating the two components. Work slowly around the edges to avoid bending or damaging the frame.

![I5_2.jpg](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_2_e4c51543-89e1-4fd0-89ed-6b470ffb089c.jpg?v=1772459372)
![I5_3.jpg](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_3_1402afe1-a0d5-4dc3-9906-b39449bced9e.jpg?v=1772459378)

---

### 4. Lift the Backplate Carefully

Once the edges are separated, lift the backplate to around **90°**. You’ll see **two ribbon cables** connecting it to the mainboard — carefully disconnect these before fully removing the backplate.

![I5_4.jpg](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_4.jpg?v=1772459256)
![I5_5.jpg](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_5.jpg?v=1772459261)
![I5_6.jpg](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_6.jpg?v=1772459266)

---

### 5. Disconnect the Display Connector

Lift the fine clamp on the display connector and gently pull the cable out to disconnect it.

![image](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_34.jpg?v=1724413283)
![image](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_35.jpg?v=1724413484)

---

### 6. Reconnect the Display Cable

Insert the display connector back in **as far as it will go**, ensuring it’s **straight and fully seated**.
The **white line** on the connector should align perfectly with the clamp and be **barely visible**.

![image](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_37.jpg?v=1724415224)

---

### 7. Reattach the Ribbon Cables and Backplate

Before closing the device, make sure the **ribbon cables** are fully inserted and straight. The **white lines** on the cables should **not be visible** once properly connected.

![image](https://cdn.shopify.com/s/files/1/2059/5897/files/I5_38.jpg?v=1724415225)**Tip:** When reattaching the backplate, start by lining up the **camera** first, then gently press around the edges until it clicks back into place.