Installing SATA Drive in a Byte

Follow steps 1-4 of the Byte Complete Disassembly Guide to separate the chassis from the PCBA. Byte_SATA1.jpg

Carefully remove the black tape holding down the SATA connector.
Byte_SATA2.jpg

Gently pull upwards on the end connected to the PCBA to disconnect.
Byte_SATA3.jpg

Slide the connector into the drive, aligning the longer and shorter end accordingly. (It should only be able to fit in one way)
Byte_SATA4.jpg

Remove 4 x black screws that attach the SSD mount rails to the inside of the chassis to remove the rails.
Byte_SATA5.jpg

Using the 4 x short screws in the package containing the VESA mount, attach the mount rails to each side of the SSD.
Byte_SATA6.jpg

Byte_SATA7.jpg

Reattach the SSD mount rails to the chassis using the same 4 x screws.
Byte_SATA8.jpg

Reattach the SSD connector to the PCBA (white dot facing up)
Byte_SATA9.jpg

Jun 5, 2024

Contact Us

Not finding what you're looking for? Contact Us Directly