1. Start with the Star Lite Mk V on a soft, protected surface to avoid any possible scratching.
2. Remove Micro SD card tray (you will need to insert a pin into the hole to pop it out)
3. Using the plastic pick, gently wedge this between the display and the backplate to separate the two components away from each other.
4. Carefully lift the backplate 90' degrees as you will need to separate two ribbon cables that are attached to the backplate and the mainboard.
5. Disconnect the display connector by lifting up the fine clamp and gently pulling out the cable.
6. Insert the display connector back in as far as it will go and ensure that it is straight.
The white line on the connector should be completely aligned with the clamp and only just visible.
7. Remember to reattach the ribbon cables before reattaching the back plate. Ensuring these are also fully inserted and straight. The white line on these cables should not be visible.
Note: When reattaching the backplate start by lining up the camera first, and then gently pushing around the edges to clip the backplate back into place.